I have a HONDA Dio110 JF58 & it looks exactly the same as the JF31 where the knuckle visors fit so I ordered one set.The mounting points do not match exactly so I have not fitted them. It is disappointing, but I knew it was a gamble on my part.
There is only OEM, the connection with Body is beautifully finished.
Installation was unexpectedly simple, but a 6 mm Drill is required.
I think it would be better to have electric Drill.
One Side got clean, but the other opened a hole from the top of the paper, so it got a little off.
I think that it is better to mark Small Mark from the top of the paper pattern, remove the paper pattern, then apply the Guard again and check.
It is a warm season now, but I do not feel it, but I am looking forward after it got cold.
I am attaching Grip heater, but I hope that it can be solved with this because the fingertips and back of the hand will cool down.
Later, I think that it should be 2 to 3 cm longer, but is it avoiding to hang and break?View Detail
In attachment, the two bottom (in motorcycle side, hole is already vac
Although it had equipped with the hot grip of the daytona, the knuckle visor which the back of the hand got cold, and was worried from before since it was unavoidable was purchased.
In attachment, the two bottom (in motorcycle side, hole is already vacant) upper part vacates one-place a 6-mm hole.
Although other manufacturers' knuckle visor was also considered, an authentic positive one was chosen and it was a correct answer.
A using feeling is the highest.
I did not think that there was an effect like this! Those who have not attached should attach absolutely.
I can progress.View Detail
CỬA HÀNG LỚN NHẤT
TẠI NHẬT BẢN
COUPON ĐẶC BIỆT,
GIẢM GIÁ, KHUYẾN MÃI
DỊCH VỤ GIAO HÀNG
NHANH, MIỄN PHÍ